At these frequencies, radiated EMI from switching regulators is produced mainly by switching voltage ringing and spikes, and can depend heavily on PCB board layout. Industry standards for radiated emissions usually cover the frequency band from 30 MHz to 1 GHz. In a switch-mode supply, radiated EMI is usually generated by high dv/dt noise at the switching nodes. There are two major type of EMI: radiated and conducted. Different Types of EMI: Radiated and Conducted Noise, Common Mode, and Differential Mode

To speed up the process of EMI filter design to meet EMI specifications, this article shows how conducted EMI noise analysis and filter design can be easily estimated and prebuilt using ADI’s LTpowerCAD ® program. Unfortunately, EMI analysis and filter design can be a difficult task, typically requiring a time-consuming iterative process of design, build, testing, and redesign-that is, assuming one has proper test equipment. To meet these limits for a switch-mode supply, one must first quantify its EMI performance and, if necessary, add proper input EMI filtering to attenuate the EMI. Because of this, many standards have arisen to set acceptable limits on EMI. The problem is that high frequency noise can couple to other devices in the system, degrading the performance of sensitive analog or digital signal circuits. Fast turn-on and turn-off of power transistors create sudden interruptions of current flow, resulting in high frequency voltage ringing and spikes. For example, the input side switch current of a typical buck converter is a pulsating current rich in harmonic content. This is commonly referred to as electromagnetic interference (EMI), EMI noise, or just noise.

One side effect of the proliferation of switch-mode supplies is the noise they produce. Switch-mode power supplies are used throughout modern electronics systems mainly because of their high efficiency power conversion. Speed Up the Design of EMI Filters for Switch-Mode Power Supplies

Inductor filter design